HALT(8) Linux System Administrator's Manual HALT(8)NAME
halt, reboot, poweroff - stop the system.
SYNOPSIS
/sbin/halt [-n] [-w] [-d] [-f] [-i] [-p] [-h]
/sbin/reboot [-n] [-w] [-d] [-f] [-i]
/sbin/poweroff [-n] [-w] [-d] [-f] [-i] [-h]
DESCRIPTIONhalt notes that the system is being brought down in the file
/var/log/wtmp, and then either tells the kernel to halt, reboot or
power-off the system.
If halt or reboot is called when the system is not in runlevel 0 or 6,
in other words when it's running normally, shutdown will be invoked
instead (with the -h or -r flag). For more info see the shutdown(8)
manpage.
The rest of this manpage describes the behaviour in runlevels 0 and 6,
that is when the systems shutdown scripts are being run.
OPTIONS-n Don't sync before reboot or halt. Note that the kernel and stor‐
age drivers may still sync. This implies -d.
-w Don't actually reboot or halt but only write the wtmp record (in
the /var/log/wtmp file).
-d Don't write the wtmp record.
-f Force halt or reboot, don't call shutdown(8).
-i Shut down all network interfaces just before halt or reboot.
-h Put all hard drives on the system in stand-by mode just before
halt or power-off.
-p When halting the system, switch off the power. This is the
default when halt is called as poweroff.
DIAGNOSTICS
If you're not the superuser, you will get the message `must be supe‐
ruser'.
NOTES
Under older sysvinit releases , reboot and halt should never be called
directly. From release 2.74 on halt and reboot invoke shutdown(8) if
the system is not in runlevel 0 or 6. This means that if halt or reboot
cannot find out the current runlevel (for example, when /var/run/utmp
hasn't been initialized correctly) shutdown will be called, which might
not be what you want. Use the -f flag if you want to do a hard halt or
reboot.
The -h flag puts all hard disks in standby mode just before halt or
power-off. Right now this is only implemented for IDE drives. A side
effect of putting the drive in stand-by mode is that the write cache on
the disk is flushed. This is important for IDE drives, since the kernel
doesn't flush the write cache itself before power-off.
The halt program uses /proc/ide/hd* to find all IDE disk devices, which
means that /proc needs to be mounted when halt or poweroff is called or
the -h switch will do nothing.
AUTHOR
Miquel van Smoorenburg, miquels@cistron.nl
SEE ALSOshutdown(8), init(8)
Nov 6, 2001 HALT(8)
